How to set up for RPM sensor
How to set up for RPM sensor
How to set up for RPM sensor Please give pics for a Spectrum radio. and what RX to use. In Q/500
2 wrongs don't make a right But 2 Wrights makes a Airplane
Kevin Matney http://www.Matneymodels.com
734 - 848 - 8195
"IN GOD WE TRUST " 44W
Kevin Matney http://www.Matneymodels.com
734 - 848 - 8195
"IN GOD WE TRUST " 44W
Re: How to set up for RPM sensor
The sensor fits in the backkplate of the motor. I take off the bracket and silicone the sensor in the backplate. You have to use either a 6600T, 7350 or 9350 Spektrum receiver.
Re: How to set up for RPM sensor
What Mike said with a picture...I've had success with zap a dap a goo.
Re: How to set up for RPM sensor
I know we've talked about this Mike, but without a magnet, what's the thing reading? Some magnetic field off the crank pin? If so, wow! What technology!
Tim Lampe
Tim Lampe
Re: How to set up for RPM sensor
There is a magnet built into the sensor and it senses the crank pin rotation.
Re: How to set up for RPM sensor
Its an "active" hall effect device. The crank pin disrupts the magnetic field and the sensor senses this.
-
- Super Contributor
- Posts: 129
- Joined: Thu Aug 27, 2015 6:19 pm
Re: How to set up for RPM sensor
This same setup is very common for nitro RC helicopters, is been used for many years on their RPM governors
Re: How to set up for RPM sensor
thank all, how do route the wire?
2 wrongs don't make a right But 2 Wrights makes a Airplane
Kevin Matney http://www.Matneymodels.com
734 - 848 - 8195
"IN GOD WE TRUST " 44W
Kevin Matney http://www.Matneymodels.com
734 - 848 - 8195
"IN GOD WE TRUST " 44W
Re: How to set up for RPM sensor
Route the wire through the firewall to the receiver.