Landing Gear Installation - #4 Phoenix

Building and other racing tips and suggestions.
Post Reply
sahartman21
Super Contributor
Posts: 597
Joined: Thu Jan 10, 2008 8:52 pm
Location: Fritch, TX 79036

Landing Gear Installation - #4 Phoenix

Post by sahartman21 »

This is the fourth of many short tips on how to finish a composite Q500. They are based upon installation in a "Phoenix" that is currently being produced by Jim Lime (eight zero six - 553-5478).

I reused an existing gear from a National Balsa "Intimidator" that I had wrecked awhile back.

The wheels are a urethane type that are available from Darol Cady or other racing supply sites.

The gear is attached with 6 - 32 button head type screws and blind nuts.
Attachments
IMG_8009.JPG
IMG_8010.JPG
IMG_8011.JPG
IMG_8012.JPG
IMG_8014.JPG
IMG_8015.JPG
Scott Hartman
Fritch, TX 79036
sahartman21
Super Contributor
Posts: 597
Joined: Thu Jan 10, 2008 8:52 pm
Location: Fritch, TX 79036

Re: Landing Gear Installation - #4 Phoenix

Post by sahartman21 »

Continue to the next post:

viewtopic.php?f=12&t=5389
Scott Hartman
Fritch, TX 79036
Post Reply