Landing Gear Installation - #4 Phoenix
Posted: Sun May 29, 2016 6:12 pm
This is the fourth of many short tips on how to finish a composite Q500. They are based upon installation in a "Phoenix" that is currently being produced by Jim Lime (eight zero six - 553-5478).
I reused an existing gear from a National Balsa "Intimidator" that I had wrecked awhile back.
The wheels are a urethane type that are available from Darol Cady or other racing supply sites.
The gear is attached with 6 - 32 button head type screws and blind nuts.
I reused an existing gear from a National Balsa "Intimidator" that I had wrecked awhile back.
The wheels are a urethane type that are available from Darol Cady or other racing supply sites.
The gear is attached with 6 - 32 button head type screws and blind nuts.