This is the fourth of many short tips on how to finish a composite Q500. They are based upon installation in a "Phoenix" that is currently being produced by Jim Lime (eight zero six - 553-5478).
I reused an existing gear from a National Balsa "Intimidator" that I had wrecked awhile back.
The wheels are a urethane type that are available from Darol Cady or other racing supply sites.
The gear is attached with 6 - 32 button head type screws and blind nuts.
Landing Gear Installation - #4 Phoenix
-
- Super Contributor
- Posts: 601
- Joined: Thu Jan 10, 2008 8:52 pm
- Location: Fritch, TX 79036
-
- Super Contributor
- Posts: 601
- Joined: Thu Jan 10, 2008 8:52 pm
- Location: Fritch, TX 79036
Re: Landing Gear Installation - #4 Phoenix
Scott Hartman
Fritch, TX 79036
Fritch, TX 79036